Routing Configuration & Router Administration for Cisco CCNA

About this course

This course is over 10 hours in length and will cover everything from connecting to a router, configuring administrative tasks on the router, learning the routers internal components such as RAM, ROM, NVRAM and FLASH; learning how to manipulate the Registers on the router, backing up configurations, using the CDP protocol, and all aspects of Static, Default and Dynamic routing. Please Note: The Cisco Packet Tracer is a Cisco proprietary software and can only be given out by Cisco. So, if you hear me say in any of the lectures, that I would be providing the CPT, please disregard since I cannot do so. DISCLAIMER:   Please note that the simulators/emulators used in this course are not part of the course. It is the students responsibility to have these to practice with. The Cisco Packet Tracer and/or VIRAL (Virtual Internet Routing Lab) are Cisco proprietary software and can only be obtained through Cisco. It is up to each student to obtain the simulator/emulator of their choice to study along with this course. If you are unable to get a hold of the CPT, remember that you have other options, like: GNS3, Boson or even live equipment. It is recommended that you use any of the simulators mentioned above to follow along with the course. Students will get a thorough understanding of how the routing process actually works and they will also learn how to configure all inter-networking components using the Cisco Packet Tracer (link attached for download), look for it under external . Students will also be configuring RIPv2, EIGRP and OSPF and understand how to manipulate each routing protocols attributes to meet the requirements of the network. This is a lecture based course using the Touch-IT Technology Smart board, which will make learning very interactive and engaging. Hands on labs will